In fact on the discovery board, with respect to usart#1, I am connecting to pins Pa9 & Pa10 (same as MP32). Regarding B, this seriel configuration is working when I connect to either of the usarts on the StmDiscovery board. B) I am using an ftdi usb-232 converter with a 232 shifter smd at the end (): A picture of my configuration is at the bottom. Please, verify the boot mode configuration and the flash protection status.' Settings-Config: A) ST Flash Loader: 115200, 8, even, (echo disabled). I get the following error: 'No response from taget, the Boot loader can not be started. I am not able to get the ST Flash loader to recognize the STM32 on the MP32. If you had the necessity to program the STM32L0x1/2/3 download (ver.
ATTENTION Up to now, 10-November-2017, there is a problem to program the STM32L0x1/2/3 ( 32KFlash) using the standard Flash Loader (ver. For example for put in boot mode the is necessary connect to VCC (VDD) the boot pin that is pin 31. Remember to put your STM32 in boot mode before to run Flash Loader.
0 kommentar(er)
